#Abbyy business card reader not synching full#

If the reader lights don’t turn on, try again and make sure to firmly press and hold the reader’s button for a full 20 seconds. Try plugging the power adaptor into a different outlet.Make sure the reader is firmly plugged into the USB accessory hub of your Square Stand or into a grounded AC outlet.The tips below usually fix most charging issues customers encounter with the reader: If you see red lights, you’ve held the button too long and need to try again.Ĭheck out our video on accepting Chip Card Payments with the Square Reader for additional help. Immediately release the power button when you see the 4 orange lights. To put the reader into pairing mode, press the reader’s power button for 3-10 seconds until you see 4 orange blinking lights. Verify that your reader can go into pairing mode. Tap Settings > Hardware > Square Reader.Tap More from the navigation bar at the bottom of your screen.Once your reader is ready to be paired, open the Square app: If the lights don’t turn on, please try again and make sure to firmly press and hold the reader’s button for a full 20 seconds. If the reader lights turn green, you’re all set. Press the button again to turn the reader on and observe any lights on the reader.After 20 seconds, release the button and wait 10 seconds.Use a small object like a bobby pin, pen cap, or paper clip to firmly press and hold the button on the reader for 20 seconds or after the 4 lights stop blinking red.Plug in the reader for at least 20 minutes to be sure it’s charged.Check that your device is connected to a secure internet connection.To do so, on your device head to Settings > Privacy > Bluetooth and enable permissions for the Square app. If you’re using an iPhone or iPad on iOS 13, make sure Bluetooth permissions for the Square app are enabled.Turn on Bluetooth in your device settings.Before you attempt to connect your reader, make sure that your reader is ready to be connected.

Abbyy business card reader not synching